York, Coleman, Rheem, Ruud Honeywell, ICM Blower Control Circuit Board.
Upgraded Replacement Blower Control Circuit Board (Rheem, Coleman, Ruud)
The Robertshaw 695 series electronic blower motor controls
were designed for use on heating and cooling equipment.
The 695 controls the operation of the induced draft blower
and the cirulating blower in all thermostat modes. On a
call for heat, the induced draft blower is energized. A
pressure switch then proves the induction blower is functioning
and brings in the gas valve. Operation of the gas valve
starts the
•on
• delay timing. At the end of a pre-selected
(and fixed) delay, the circulating blower is energized and
it runs continuously until the call for heat is satisfied.
At this time, the
•off
• delay (adjustable) is initiated and
the circulation blower operates until the
•off
• delay times out.
Fan Control center Input Voltage: 18-30 VAC
Frequency: 50/60 Hz
Contact ratings:Heat/Cool Speed
N.O.: 20 amps @ 240 VAC
N.C.: 10 amps @ 240 VAC
Time delays blower off time adjustible:
90, 120, 150, 180 seconds
Replaces Circuit Board Part Numbers:
ICM-270
ICM-270C
026-34030-000
031-01267-01A
0310126701A
2702-300P
2702-300P
CARL38826
CIB69501
AC1015
AD1002
ST9120A1200
42702300
T90H5D12-24-05
SPCB-1
SPC8-1
PCB349-2
100-830-01
2895-300
026-34030
42-22827-82
42-22827-83
42-22827-01
42-22828-01
42-22828-02
422282782
422282783
422282701
422282801
422282802
ST9101A1012
ST9101A1014
2702-003
2702003
47-22827-03,
422282703,
ST9120A1004,
2895300
2895-300
695-001
CAR695001
ICM270
ICM270C
ICM-270C
CARL38650
CAR695003
CARICM270
CAR695001.
Used in Armstrong Furnace Models:
All GUA Furnaces from GUA050 to GUA150, BGU07512, BGU07512A, P1SPD16N08001A, PABULD20N125A, P1SPD16N08001A.
Used In Equipment Model Numbers:
AGU10020A
AGU10020
RGDG-100AUER
RGDG-100AVER
RGDG100AUER
RGDG100AVER
Used in Coleman York Equipment Models:
P1SPD20N08001A