Manufacturer: Johnson Controls |
|
Description: VLV,SOL,3-WAY 240 VOLT
Category: Valves
Sub Category: Solenoid Valves
V-2410 Three-Way
Multipurpose Solenoid Air Valve
Features
· Compact Size with
Durable, Solid Brass
Construction
· Can Be Mounted in Any
Position
· Conduit Adaptable to Meet
Electrical Code
Requirements (Conduit
Housing Style Models
Only)
· Readily Adaptable Air
Connections
· Positive Air Seal
· Can Be Used in Smoke
Control Applications
The V-2410 Three-Way
Multipurpose Solenoid Air Valve
is designed for use in
applications where the operation
of a pneumatic device is
dependent upon an electrical
circuit. The V-2410 diverts the
air signal to the pneumatic
device(s) when the coil is
energized or de-energized,
depending on the choice of air
connections used (N.O.
Normally Open, N.C. Normally
Closed, and COM. Common).
Operation
In a typical V-2410 application,
supply air is connected to the
N.C. port, the control device is
connected to the COM. port, and
the N.O. port is left vented.
When the solenoid is energized,
a magnetic field activates a
plunger-type valve stem, the
N.C. port opens, and supply air
is directed through the COM.
port to the control device. then
the solenoid is de-energized,the supply air connection is
closed and the N.O. port
exhausts air from the control
device. Reversed signals may
be obtained by connecting the
supply air to the N.O. port, using
the N.C. port for exhaust.
Mounting
The V-2410 can be mounted in a
variety of ways depending on
the model ordered. All models
feature two mounting holes on
the bottom of the unit for surface
mounting using two #10-32
screws (field supplied).
In addition, the V-2410-1, -2, -3,
-4, -5, -6, and -7 feature an
integral bracket for wall or panel
mounting using two #8 screws
(field supplied). These models
also feature a conduit
connection should the
application require it.
! CAUTION: All conduit
housing style V-2410s are
furnished with a ground
wire; however, if this style
of solenoid is to be
grounded via the conduit,
make sure that metallic
conduit is used to
conform with electrical
code requirements.
The V-2410-8 and V-2410-9
(yoke style models featuring
push-on spade terminals) are
shipped with a separate
mounting bracket which can be
attached to the valve base using
the two furnished #10-32
screws. The valve and bracket
assembly can then be mounted
to the surface using two #10
screws (field supplied).
Regardless of the mounting
method chosen, all models can
be installed in any position
without affecting the operation of
the unit.
! CAUTION: Where system
closure, improper flow, or
loss of pressure due to
valve failure can result in
personal injury and/or
loss of property, it is
recommended that
additional devices be
added to indicate proper
system operation (for
example, blade position
indication on damper
blades in smoke control
applications).
When the V-2410 is used in
smoke control applications, it
is recommended that the
solenoid be mounted in an
upright position as close to
the actuator as possible to
provide quick response.
Repair Information
Field repairs must not be made. Unit must be replaced.
Replaces Part Numbers: V-2410-4, CARV-2410-4