Amana, Carrier, Bryant, Goodman, Payne, Rheem, Ruud, Intercity Products, Comfortmaker, Heil, Tempstar, York Copeland 1-PHASE Compressor
* Compressor Mechanical:
Refrigerant: 22
* Compressor Electrical Data:
Voltage: 208/230
Phase:1
Replaces Compressor Part Numbers:
CR38K6PFV270
GB10UF001
H25B353ABCA
B9266-606
B9266606
GB10UF003
1082719
CR38K6-PFV-830
CR38K6-PFV830
CR38K6PFV221
34B0041N01
CR38K6-PFV
CR38K6PFV
P021-3821
COM3717
COM03717
CR38K6PFV130
CR38K6-PFV
CR38K6-PFV-130
CR37KQ-PFV
CR38K6-PFV-970
CARB94692
Used in Amana Goodman Janitrol Air Conditioning Models:
CPE36-1AB
CPE36-1A
Used in BDP, Bryant, Carrier Air Conditioning Models:
38YCA036340
38YCA036310
661NJX036000ADAA
38TKB042300
38TKB038300
661NJX036000ABAA
661AJX036000ABAA
671AJX036000ABAA
661MJX036000ABAA
38YC036310
HA1AJX036000ABAA
73HCA334301D
38TGX036310
AA1AJX042000AAAA
571AJX042000AAAA
711AJX042000AAAA
710AJX042000AAAA
38TU042300
561AJX042000AAAA
AA1BJX042000AAAA
PA10JA042000AAAA
38CK042300
AB1BJX042000AAAA
38CKM042300
38YCN036330
38YCN036310
PA11JA042000AAAA
593CJX042000ACAA
38YCM036310
38TMA042300
593CJX042000AAAA
561MJX042000AAAA
661BJX036000AEAA
661BJX036000ABAA
593BJX038000AAAA
38TKW042300
593BJX042000AAAA
661AJ036-B
661AJ036-A
Used in Air Conditioning and Heating Brands: Airquest, Arcoair, Clare, Comfortmaker, Heil, Kenmore, Tempstar, Snyder General, Intercity Products, Whirlpool and many other brands.
Used in ICP Equipment Models:
ACS042A2C1
NHP042AKA
NHPO42AKA
Used in Trane Air Conditioning Models:
TWR036C100A2
TTD736B100A1.
* IMPORTANT!!! - PLEASE NOTE: IDENTIFYING COMPRESSOR FAILURES
Most compressors fail due to system malfunctions, which must be corrected to prevent repeat failures. After a compressor fails, field examination of the failed compressor often will reveal symptoms of system problems. Proper corrections will help eliminate future failures.
* SINGLE PHASE BURN
Two phases of a three-phase motor overheated or burned as a result of the contactor opening only one of its contacts.
Correction:
(1) Replace contactors with properly sized contactors.
(2) Check for proper motor protection.
* HALF WINDING SINGLE PHASE BURN
In a two contactor application, two phases of one half of a three phase motor overheated or burned as a result of one contactor opening only one contact.
Correction:
(1) Replace contactors with properly sized contactors.
* HALF WINDING BURN
Half of all phases on a two contactor three phase motor are overheated or burned due to only one contactor opening.
Correction:
(1) Replace contactors with properly sized contactors.
(2) Check for feed back circuit holding one contactor closed.
* PRIMARY SINGLE PHASE BURN
Only one phase of a three phase motor is overheated or burned as the result of opening one phase on the primary side a delta to wye transformer.
Correction:
(1) Check primary side of a delta to wye main power transformer.
* START WINDING BURN
The start winding only of a single-phase motor is uniformly overheated or burned.
Correction:
(1) Check for proper wiring of compressor.
(2) Check starting capacitor and/or starting relay.
(3) Correct compressor overloading.
* SPOT BURN
A localized burn within a winding, between windings, or from windings to ground. If not the result of mechanical problems, check for spikes or surges of high current flow.
* SHORTED TERMINALS
A break down of the insulation between terminals and compressor body generally the result of over torquing terminals.