(OBSOLETE - No Longer Available)
White Rodgers Ignition Control Module 5 Wire Edge Connector used with Edge Connector Gas Valves, Spark Plug or 1/4" Spade Connectors.
Description of Item:
Combination Pilot Relight Control And Lockout Timer, Safety Switch, Ignition And Detection For Gas Pilots With 5 Terminal Edge Connector For Use With Edge Connect Type 36C Gas Valves, Not Interchangeable With 50A22-1 or 50A22-4
1. Turn off power to the system at the main fuse or
breaker box before beginning installation.
2. Mount the 50A22 relight/timer control in an area on
the appliance where it will not be affected by rollout
flame, flame heat, or radiant heat. Maximum ambient
temperature should not exceed 155
a. Be sure metal-to-metal contact is made between
mounting hole standoffs on 50A22 and mounting
b. Connect the high voltage lead to the terminal on
top of the 50A22, after feeding the lead through
the angled insulation boot.
Press the boot over
the connection (see fig. 2).
Avoid excessive strain
on the ignition cable, as this may cause the cable
to pull out of the ceramic. (The ignition cable is
held in the ceramic by a push-on connector.)
3. Plug the 5-wire connector from the gas valve wiring
harness into the receptacle on the 50A22 (see figs. 2
& 3). Be sure metal clips in 5-wire plug are aligned.
4. If replacing a 24 volt gas valve, attach wires previously
connect to old gas valve to the terminals on the
50A22 Relight/Timer. If replacing other control configurations,
refer to figures 5 and 6 for typical wiring.
5. Refer to fig. 4 for typical system wiring hookup. When
wiring this system, be sure the limit control is not
accidentally wired out of the circuit.
6. Inspect all existing wiring for damage, loose connections,
etc. Secure all wiring to chassis or piping with
electrical/friction tape or plastic wire-wraps so they
will not be able to contact high temperature locations.
Replaces Ignition Control Module Part Numbers: